Monday, 28 December 2020
Join My free Bible Leadership Class
Saturday, 19 December 2020
SOLAR . 3 IN ONE ONLINE CLASS
Wednesday, 16 December 2020
First-Class Tutorial
Sunday, 13 December 2020
HOW TO INSTALL SOLAR WATER BOREHOLE..
How To Install Solar Pump System?
lubi solar
November 3, 2018
Water pumping asks for a considerable power sink in the daily power utility. When it comes to irrigation a considerable part of the farmable land is far out of the reach of the power lines. Solar Pumps offer a welcome alternative to fuel burning engines, windmills and hand pumps
I) Solar Panel Solar Pump basically works on solar panels as the power source used to drive electric motors. The solar pump system basically consists of three core components.
e
II) Solar Pump
III) Solar Controller
The other components required for installation of the system are :
1: Solar Structure
2: Cable
3: Cement and gravel for civil works
INSTALLATION OF LUBI SOLAR PUMP SYSTEM
Step 1: Structure
The first step in installation of solar pump system is erection of the structure.
The solar panels required to run the electric motor are mounted on the structure. The structure provides a proper alignment of the solar panels with sun. Also the structure should possess sufficient mechanical strength to hold the solar panels against strong winds and hail. The design of the structure depends on the panel configuration that depends on the horsepower of the motor.
Ideally 1 HP = 0.746 KW
Consider the rating of the controller, as thumbrule installers consider the KW of panel as equivalent to HP of solar pump
The Lubi Solar panel configuration for Lubi make Solar Panels is as given:
1 HP – 1200W
2HP – 1800W
3HP- 3000W
5 HP – 4800W
7.5 HP – 7560W
10 HP – 10080W
![]()
Step 2: Installation
The second step in the installation of the solar pump. This requires first fixing the pump motor assembly. After the pump motor assembly tape the polyethylene pipe with thread tape and screw it to the pump. Splice the drop cable to the motor cable. Attach the steel safety cable to pump and roll out with rising main and drop cable. Attach the safety cable end to the bore cap allowing for the rising main to stretch. Check the fittings for strength and slack for stretch. Now Lower the pump into the well
STEPS 3
The final step is installation of the contoller and integration of the system. The controller is genrally mounted on the main column of the structure. The cables are then connected and checked for loose connection. The controller is then programmed for the motor configurations before finally starting it to run the motor. 3: System Integration
INSTALLATION OF WATER BOREHOLE 2
Solar Energy is a giant leap in the field of science which has enabled humans to produce clean energy.










































































